Click on the image to check the artwork
MARSIDE Series
Product Name/Model：BC1K Pearl Colors
Characteristic:BC1K Pearl Colors with excellent leveling property,easy construction,excellent
adhesion power and coveraging power,can match all kinds of solid colors, metallic and pearl
effect. Mainly applies to intermediate cars, MPV and bus.
Substrates Well-Sanded, Completely dried and good existing finishes as bellow:
A original paint B. Old paint firm C. 1K or2k primer
Surface
Cleaning Wash by warm soap, remove wax, silicon and other contaminations with
degreaser, sanding with P800-P1000, wash with clean water then keep dry;
again with degreaser.
Mixing Ratio BC1K Pearl Colors Thinner
1 1
A 、＜15℃ ：90 Fast Thinner； B 、 15-30℃：91 Standard Thinner； C、＞30℃：92Slow Thinner
Spray Viscosity 14-16s to drop off, in 4# viscosity cup at 25°C,
ReTreatment After spray, allow 10-20 minutes air-drying time,then spray clear coat at once.
Spray Gun Set Up Gravity Feed: 1.2-1.5mm 3-5kg/cm²
Suction Feed: 1.4-1.6mm 3-5kg/cm²
Spray Technology Coats&Thickness: 2-3 coats, total 15-20um.
Flash-Off Time: At 25°C, 5-10 minutes between two coats, it depends on
temperature and paint film.
Shelf Life 2 years in original sealed can, cool and dry place at 25℃.
Package 1L×12 or 3.75L×4
Note:
1. The substrate must be cleaned and sanded before spray, wet sanding P800-1000 and then dry.
2. At ambient temperature higher than 30℃, add appropriate Retarder Solvent into thinner to
avoid blushing. For more details, please refer to technical data sheet of Retarder Solvent.
3. To avolid problems of mottling or poor adhesion, the metallic paint film should be 15-25um.
BC1K Pearl Colors